Product details
Introduction:
24.18 A gauge according to figure 35, applied with a force of 1 N shall not enter more than
1,0 mm from the upper part of any groove, hole or reverse taper, or the like, when the gauge
is applied parallel to the mounting/supporting surface and perpendicular to the part under test,
as shown in figure 36.
NOTE Verification as to whether, according to figure 35, the gauge has entered by more than 1,0 mm is made
with reference to a surface perpendicular to face B and including the upper part of the outline of the grooves,
holes, reverse tapers or the like.
Consulting
Fill out the form
